Subdivision rules in Logan

Building a subdivision in Logan? Logan City Council applies the Queensland planning framework. Here's what that means locally — plus the overlays worth checking on your specific block.

Depends on your lot

Reconfiguring a lot - assessed against your council's planning scheme

In Queensland subdivision is called reconfiguring a lot, and whether you can do it turns on the minimum lot size, frontage and lot shape your council's planning scheme sets for your zone and precinct. In Brisbane's Low Density Residential zone that is commonly 400 m² for a standard lot and 600 m² for a rear (battle-axe) lot, but each of Queensland's councils sets its own figures.

Logan: assessed by Logan City Council under the Queensland rules below.

Approval pathway: Reconfiguring a lot (ROL) is development under the Planning Act 2016. Unless your council's planning scheme lists your proposal as accepted development, you lodge a development application with the council, which assesses it either as code assessable (measured against the scheme's benchmarks, no public notice) or impact assessable (public notification and submissions, and a wider merits assessment). Once approved you satisfy the conditions and complete any required works, a cadastral surveyor prepares the survey plan, the council seals (endorses) that plan, and it is lodged with Titles Queensland to create the new titles.

Key rules at a glance

Minimum lot size	Set by your council's planning scheme for your zone and precinct - commonly 400-600 m² in low density residential zones, with rear lots typically larger (indicative), mapped per property
Approval needed	Development approval for reconfiguring a lot, unless the planning scheme lists it as accepted development
Assessed by	Your local council, as code assessable or impact assessable development under the Planning Act 2016
Frontage	Set by the planning scheme - commonly 10-15 m for a standard lot, with a narrower access handle permitted for rear lots (indicative)
Typical timeframe	About 3-4 months for a compliant code assessable application (some councils offer a fast-track, such as Brisbane's RiskSMART), longer for impact assessment; roughly 9-18 months to titles overall (indicative)
Title created	Freehold lots on a sealed survey plan; a community titles scheme is the alternative where lots share common property
Final step	Council plan sealing, then lodgement with Titles Queensland

Overlays can change your eligibility

Heritage, flood and bushfire controls on your specific lot can remove the fast-track and require a full application — even when the general rules say you're fine.

HeritageFloodBushfire

Check your address for overlays →

Subdivisions in Logan

Logan City Council is the authority for Logan in Greater Brisbane. The statewide Queensland rules above set the baseline; the council can apply extra local controls, and heritage, flood or bushfire overlays on your lot can change what's allowed.

Visit Logan City Council ↗ Full Queensland rules →

Frequently asked questions

Do I need council approval for a subdivision in Logan?

Usually yes. In Queensland, a subdivision generally needs an application, and Logan City Council is the authority that assesses it. See the full state rules for the pathway and what's required.

Which council approves a subdivision in Logan?

Logan City Council is the consent authority for Logan (Greater Brisbane). You can review local planning controls on the council website and lodge through your state planning portal.

What is the minimum land size for subdivision in Queensland?

There is no statewide figure - it is set by your council's planning scheme for your zone and precinct. As an indicative example, Brisbane's Low Density Residential zone commonly requires 400 m² for a standard front lot and 600 m² for a rear lot, with a reduced figure close to some centres. Other councils use different numbers, so the only reliable answer is the one mapped for your address.

Sources

Last reviewed: July 2026. Rules can change — verify with your council before starting work.

Related building rules

General guidance only — not professional planning advice. Local requirements in Logan can differ from the statewide summary and change over time; always confirm with Logan City Council before starting work. Last reviewed: July 2026.

Get free quotes in Logan

Tell us what you're building. We'll connect you with licensed local builders and designers who know the council requirements — no obligation, no cost.

Licensed, local trades
Compare quotes before you commit
No cost, no obligation