Fences rules in Logan

Building a fence in Logan? Logan City Council applies the Queensland planning framework. Here's what that means locally — plus the overlays worth checking on your specific block.

Fast-track available

No building approval for a domestic fence up to 2 m

A domestic fence up to 2 m above natural ground level needs no building approval anywhere in Queensland. Over 2 m - or if the fence forms part of a regulated pool barrier - you need building approval from a private building certifier.

Logan: assessed by Logan City Council under the Queensland rules below.

Approval pathway: Fences are assessed under the Building Act 1975 and the Queensland Development Code rather than by a planning application in most cases. Up to 2 m a fence associated with an existing house is accepted development needing no approval. Above 2 m, or where the fence is part of a swimming pool barrier or is combined with a retaining wall, you need a building approval (development permit for building work) from a building certifier.

Key rules at a glance

Max height (front setback)	2 m applies to all boundaries, but on a corner lot the fence must not exceed 1 m in the 6 m by 6 m sight triangle
Max height (side/rear)	2 m above natural ground level without building approval
Combined height	Height is measured as fence plus any screen and any retaining wall beneath it - a 1.2 m wall with a 1.2 m fence is 2.4 m and needs approval
Approval needed?	No approval to 2 m; building approval from a certifier above 2 m or where it forms part of a pool barrier
Pool fence	Min 1.2 m, compliant with QDC MP 3.4 (which calls up AS 1926.1); a dividing fence used as a pool barrier must be at least 1.8 m
Dividing fence law	Neighbourhood Disputes (Dividing Fences and Trees) Act 2011
Who pays?	Adjoining owners contribute equally to a sufficient dividing fence - for residential land that means a fence between 0.5 m and 1.8 m that substantially encloses the land

Overlays can change your eligibility

Heritage, flood and bushfire controls on your specific lot can remove the fast-track and require a full application — even when the general rules say you're fine.

HeritageFlood

Check your address for overlays →

Fences in Logan

Logan City Council is the authority for Logan in Greater Brisbane. The statewide Queensland rules above set the baseline; the council can apply extra local controls, and heritage, flood or bushfire overlays on your lot can change what's allowed.

Visit Logan City Council ↗ Full Queensland rules →

Frequently asked questions

Do I need council approval for a fence in Logan?

Often not. Queensland allows a fence to proceed without a full development application when it meets the standards, and Logan City Council follows that framework. But local overlays — heritage, flood or bushfire — can remove the fast-track, so check your exact address before you rely on it.

Which council approves a fence in Logan?

Logan City Council is the consent authority for Logan (Greater Brisbane). You can review local planning controls on the council website and lodge through your state planning portal.

How high can a fence be in Queensland without approval?

Up to 2 m above natural ground level for a domestic fence on an existing house lot. Above 2 m you need building approval from a private certifier, and the height includes any retaining wall underneath.

Sources

Last reviewed: July 2026. Rules can change — verify with your council before starting work.

Related building rules

General guidance only — not professional planning advice. Local requirements in Logan can differ from the statewide summary and change over time; always confirm with Logan City Council before starting work. Last reviewed: July 2026.

Get free quotes in Logan

Tell us what you're building. We'll connect you with licensed local builders and designers who know the council requirements — no obligation, no cost.

Licensed, local trades
Compare quotes before you commit
No cost, no obligation